Research Report Library > Reports
Report
L51912 Corrosion-CP Monitoring of Locations Remote from a Test Station
Abstract
It is accepted that many situations exist on pipelines where a significant length of the pipeline (typically 2000 ft to 5 miles) is either totally inaccessible or access is so difficult or expensive that monitoring is not done at the required frequency. The need for finding a technique to allow the corrosion engineer to monitor CP levels of inaccessible locations from an accessible remote location has therefore been identified.
A study to investigate all possible techniques available to achieve the above objective and to analyze typical scenarios requiring this approach has therefore been undertaken. Numerous techniques varying from pipe-to-soil type measurements, above ground current attenuation measurements, direct measurement of pipeline current, and measurement of the AC impedance response of the inaccessible section of pipeline were identified. In addition, some novel remote monitoring methods applicable to hostile inaccessible locations were identified. Analysis of these techniques in relation to the problem lead to the development of an algorithm to facilitate the choice of possible techniques under specific conditions.
Digital Access
After purchase, you will receive a download link to the report you purchased. Please confirm the email address you use to purchase the report is the email address you would like to receive the report.
If you have any trouble receiving the download instructions, please first check any spam or junk folders. Reach out to support if you need further assistance.
L51912 Corrosion-CP Monitoring of Locations Remote from a Test Station
Quantity
Digital products are limited to 1 per purchase
List Price
$495
Member Price
$0
Members will be redirected to a member-only report database for access to all reports. You must have a login to access reports for free.
